Samtec Logo
Having Trouble?
Contact an Engineer

Mated Set Details

Mates

Stack Height

Positions

Update Your Mated Set

Terminal:

Terminal DESCRIPTION:

Socket:

Socket DESCRIPTION:

Order Your Free Samples ↓

The data in the initial plot below reflects the insertion loss performance of the selected mated set in a single-ended, GND-SIG-GND pinout configuration and does not include crosstalk. The PCB material used in this simulation is Isola FR408, and the PCB trace on each side of the connector in the simulation is a 0.1 cm long, 50 ohm Microstrip trace.

Change any of these default values below to explore other simulation scenarios, then click on the Run Insertion Loss simulation button. To view crosstalk on the graph, check the Show Crosstalk button. For an Eye Diagram of the mated set based on your specific simulation parameter, click the Create Eye Diagram button.

  • Interconnect Impedance (Ohms)

  •  

  • Simulation Type

  •  

  • Display Bandwidth (GHz)

  • (1 - 20 GHz)

  • Trace Type

  •  

  • Trace Length 1 (centimeters)

  • (0.1-100cm)

  • Trace Length 2 (centimeters)

  • (0.1-100cm)
  • Trace Width:
  • Trace to Trace Space:
  • Trace Pair Space:
  • um
  • um
  • um
  • Upper Thickness:For Microstrip trace cross-section, the Upper Dielectric Thickness is for the Solder Mask.
  • Lower Thickness:
  • Trace Thickness:
  • um
  • um
  • um
  • Number Simulation Bits:
  • Simulation Step Size:
  • 10000
  • 0.01
  • Bits
  • Ghz

Simulation graphic representation

Simulation Details ↑
Create Eye Diagram
Run Insertion Loss Simulation

Send the information from this page as an email.

Calculated, Insertion Loss 3dB point =

* For simulations that exceed 16Gbps, please contact SIG to request an eye diagram for your specific data rate.

Insertion Loss Simulation

Crosstalk Simulation

Previous Insertion Loss 3 dB point =

* For simulations that exceed 16Gbps, please contact SIG to request an eye diagram for your specific data rate.

Previous Insertion Loss Simulation

PREVIOUS Crosstalk Simulation

Order Your Free Samples

Order samples today. Have them at your door tomorrow.

Order Your Free Samples

* A small minority of samples may take slightly longer than 24 hours.

* Co-developed by Teraspeed® Consulting Group LLC

Samtec, Inc. makes no warranty or guarantee as to the suitability of its products or models for any specific application. Samtec, Inc. reserves the right to make changes to any of our electrical models, the Solutionator® or the Simulator™ at any time without further notice.

Models used in the Simulator™ were developed using nominal values for physical dimensions and material properties and specific grounding and boundary conditions. Actual in-circuit performance can vary significantly from simulated results. All parameters should be validated by the customer's own technical experts.

Information contained in these programs are "as is", and Samtec, Inc. does not warrant or represent the use of the Solutionator® or Simulator™ programs and/or the materials within them in terms of their accuracy, reliability or otherwise. The use of these programs and their content in your specific application is done so at your own risk.

Neither Samtec, Inc. nor any party involved in creating, producing, or delivering the information contained within the Solutionator® and Simulator™ shall be liable for any direct, incidental, consequential, indirect or punitive damaged arising from the use of these programs or any errors or omissions in their content.

High Speed Board-To-Board Support: 1-800-samtec-9  |  1-812-944-6733  |  Contact an Engineer